Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 349

E805-0001-05
Detection Description
Remedy
E805-0002-05
Detection Description
Remedy
E805-0008-05
Detection Description
Remedy
E805-0009-05
Detection Description
Remedy
E808-0001-05
Detection Description
Remedy
E840-0001-05
Detection Description
Remedy
E880-0001-00
Detection Description
Remedy
E880-0003-00
Detection Description
Remedy
E880-0005-00
Detection Description
Remedy
Cartridge Upper Fan error.
It was detected that the Cartridge Upper Fan was locked.
Replacement of Cartridge Upper Fan.
Cartridge Lower Fan error.
It was detected that the Cartridge lower Fan was locked.
Replacement of the Cartridge Lower Fan.
Duplex Fan error.
It was detected that the Finisher Fan was locked.
Replacement of the Duplex Fan.
Laser Scanner Fan error.
It was detected that the Laser Scanner Fan was locked.
Replacement of the Laser Scanner Fan.
Low Voltage Power Supply Failure
- 24V Power Supply error
[Related parts]
- Low Voltage Power Supply Unit
[Remedy] Check/replace the related harness/cable, connector and parts.
Pressure Release Mechanism error
An error was detected at the pressure/separation operation.
[Related parts]
- Fixing Assembly
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Controller Fan error
It was detected that the Controller Fan was locked.
[Related parts] R1.00
- Cable between the Main Controller PCB (UN25/J15) and the Controller Fan (FM12)
- Controller Fan (FM12)
- Main Controller PCB (UN25)
[Remedy] Perform the following in the order while checking whether the error is cleared.
- Check the connectors of the Controller Fan.
- Visually check rotation of the Controller Fan.
a. If it is not rotated, replace the Controller Fan.
b. If it is rotated, replace the Main Controller PCB.
Controller Fan error
It was detected that the Controller Fan was locked.
[Related parts] R1.00
- Cable between the Main Controller PCB and the Controller Fan
- Controller Fan
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
- Check the connectors of the Controller Fan.
- Visually check rotation of the Controller Fan.
a. If it is not rotated, replace the Controller Fan.
b. If it is rotated, replace the Main Controller PCB.
Error in Controller Fan
Fan lock of the HDD Cooling Fan was detected
Check if the connector is connected.
It the connection is OK, replace the HDD Cooling Fan.
338
7. Error/Jam/Alarm