Option (Specification Setting Mode) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

FEEDER (ADF service mode) > FUNCTION (Operation / inspection mode)
FAN-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
MTR-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
ROLL-CLN 1
Detail
Use Case
Adj/Set/Operate Method
FEED-ON 1
Detail
Use Case
Adj/Set/Operate Method
Related Service Mode

OPTION (Specification setting mode)

FEEDER (ADF service mode) > OPTION (Specification setting mode)
R-ATM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Operation check of DADF fan
To start operation check of the fan specified by FAN-CHK.
At operation check
1) Select the item, and then press OK key.
It is driven for approximately 5 seconds and is automatically stopped.
2) Press OK key.
The operation check is completed.
Be sure to press the OK key again after execution. The operation automatically stops after
approximately 5 seconds, but is not completed unless the OK key is pressed (STOP is not
displayed).
FEEDER> FUNCTION> FAN-CHK
Operation check of DADF Motor
To drive the DADF Motor for approximately 5 seconds.
When checking the operation of the DADF Motor
1) Select the item, and then press OK key.
It is driven for approximately 5 seconds and is automatically stopped.
2) Press OK key.
The operation check is completed.
Be sure to press the OK key again after execution. The operation automatically stops after
approximately 5 seconds, but is not completed unless the OK key is pressed (STOP is not
displayed).
During operation: ACTIVE, When operation finished normally: OK!
FEEDER> FUNCTION> MTR-CHK
Rotation of DADF rollers
To rotate the rollers of DADF for cleaning.
Check the rollers with lint-free paper moistened with alcohol while they are rotating.
When cleaning the rollers
1) Select the item, and then press OK key.
2) Clean the rotating rollers with lint-free paper moistened with alcohol.
3) Press OK key.
The rollers stop.
Operation check of DADF individual feed
To start operation check of the feed mode specified by FEED-CHK.
At operation check
Select the item, and then press OK key.
FEEDER> FUNCTION> FEED-CHK
Set DADF double feed dtct highland mode
To set the Double Feed Sensor of the DADF to the highland mode.
Set 1 if the installation site is above the altitude of 2000 meters.
When the installation site is above the altitude of 2000 meters at installation
Enter the setting value, and then press OK key.
0 to 1
0: Normal, 1: Highland mode
0
607
8. Service Mode