Figure 161 Ip Configuration: Vrrp: New; Table 123 Ip Configuration: Vrrp: New - ZyXEL Communications Version 1.03 User Manual

Figure 161 IP Configuration: VRRP: New

The following table describes the labels in this screen.

Table 123 IP Configuration: VRRP: New

LABEL
Active
Name
Network
Virtual Router ID
Advertisement
Interval
Preempt Mode
Priority
Uplink Gateway
Primary Virtual IP
Secondary Virtual IP
OK
Cancel
NetAtlas Workgroup User's Guide
DESCRIPTION
Select this option to enable this VRRP interface.
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Select an IP domain to which this VRRP entry applies.
Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
Specify the number of seconds between Hello message transmissions. The
default is 1.
Select this option to activate preempt mode.
Enter a number (between 1 and 254) to set the priority level. The bigger the
number, the higher the priority.
This field is 100 by default.
Enter the IP address of the uplink gateway in dotted decimal notation.
The switch checks the link to the uplink gateway.
Enter the IP address of the primary virtual router in dotted decimal notation.
This field is optional. Enter the IP address of a secondary virtual router in
dotted decimal notation. This field is ignored when you enter 0.0.0.0.
Click OK to apply the changes and close this screen.
Click Cancel to discard all changes and close this screen.
Chapter 19 IP Configuration
219