Configuring Dhcp Relay; Figure 152 Ip Configuration: Dhcp: Server: New; Table 113 Ip Configuration: Dhcp: Server: New - ZyXEL Communications Version 1.03 User Manual

Chapter 19 IP Configuration

Figure 152 IP Configuration: DHCP: Server: New

The following table describes the labels in this screen.

Table 113 IP Configuration: DHCP: Server: New

LABEL
VID
Client IP Pool
Starting
Size of Client
IP Pool
IP Subnet
Mask
Default
Gateway
Primary/
Secondary
DNS Server
Apply
Cancel

19.5.3 Configuring DHCP Relay

Configure DHCP relay on the switch if the DHCP clients and the DHCP server are not in the
same subnet. During the initial IP address leasing, the switch helps to relay network
information (such as the IP address and subnet mask) between a DHCP client and a DHCP
server. Once the DHCP client obtains an IP address and can connect to the network, network
information renewal is done between the DHCP client and the DHCP server without the help
of the switch.
206
DESCRIPTION
Enter the ID number of the VLAN group to which this DHCP settings apply.
Specify the first of the contiguous addresses in the IP address pool.
Specify the size, or count of the IP address pool.
Enter the subnet mask of the DHCP server.
Enter the IP address of the default gateway device.
Enter the IP addresses of the DNS servers. The DNS servers are passed to the
DHCP clients along with the IP address and the subnet mask.
Click Apply to save the changes and close this screen.
Click Cancel to discard all changes and close this screen.
NetAtlas Workgroup User's Guide