Loopback Test - ZyXEL Communications Version 1.03 User Manual

Chapter 9 Fault
Table 44 Fault: Event Log (continued)
LABEL
Alarm Type
Severity
Sorted by
Date / To
Apply
Index
Clear
ClearTime
ClearUser
Ack
AckTime
AckUser
Type
Severity
Device Name
Port
Date Time
Description
Acknowledge
Delete
Close

9.2 Loopback Test

Follow the steps below to perform an internal loopback test.
1 Click Fault > Loopback Test.
102
DESCRIPTION
Select the type of logs from the drop-down list box. Choices are All,
Communication, QualityOfService, ProcessingError, Equipment and
Environmental.
Select All for system event logs generated by all alarm types.
Select Communication for transmission and signal logs.
Select QualityOfService for performance logs.
Select Processing Error for software and configuration problem logs.
Select Equipment for hardware-related logs.
Select Environmental for environmental logs.
See the appendix for a more detailed list of possible alarm causes.
Select the severity level of the logs you want to display from the drop-down list
box. The choices and associated colors are as follows:
• Critical - Red
• Major - Orange
• Minor - Yellow
• Information - Blue
Select Log Time to sort event logs by the time at which they were generated or
select Device Name to sort event logs by the device from which they were
generated.
Specify the time range to display the event logs.
Click Apply to display event logs generated within the specified time period.
This field displays the index number of the event log.
This field displays whether this log was cleared.
This field displays when this log was cleared.
This field displays the name of the user who cleared this log.
This field displays whether a log has been acknowledged so that EMS users will
know when a log has been dealt with by an administrator.
This field displays the date and time this log was acknowledged.
This field displays the name of the user who acknowledged this log.
This field displays the type of the event log.
This field displays the severity of the event log.
This field displays the name of the device on which the event log was generated.
This field displays the port number on which the event log was generated.
This field displays the date and time when the event log was generated.
This field displays some information about the event log.
Click Acknowledge to acknowledge any selected log messages.
Click Delete to remove the selected log.
Click Close to close this screen.
NetAtlas Workgroup User's Guide