Chapter 17 Multicast Configuration
17.2 Multicast Settings
To configure multicast settings, click Configuration > Multicast Configuration to display
the configuration screen.
For devices that do not support the multicast feature, this screen only allows
you to configure the IGMP Snooping option.
Figure 128 Multicast Configuration: Multicast Settings
The following table describes the labels in this screen.
Table 93 Multicast Configuration: Multicast Settings
LABEL
IGMP Snooping
Host Timeout
Leave Timeout
802.1p Priority
IGMP Filtering
180
DESCRIPTION
Select Active to enable IGMP snooping to forward group multicast traffic only to
ports that are members of that group.
Specify the time (from 1 to 16,711,450) in seconds that elapses before the switch
removes an IGMP group membership entry if it does not receive report messages
from the port.
Enter an IGMP leave timeout value (from 1 to 16,711,450) in seconds. This
defines how many seconds the switch waits for an IGMP report before removing
an IGMP snooping membership entry when an IGMP leave message is received
from a host.
Select a priority level (0-7) to which the switch changes the priority in outgoing
IGMP control packets. Otherwise, select No-Change to not replace the priority.
Select Active to enable IGMP filtering to control which IGMP groups a subscriber
on a port can join.
NetAtlas Workgroup User's Guide