Alarm Config; Figure 141 Rmon Configuration: Event Config.: New; Table 102 Rmon Configuration: Event Config.: New - ZyXEL Communications Version 1.03 User Manual

Figure 141 RMON Configuration: Event Config.: New

The following table describes the labels in this screen.

Table 102 RMON Configuration: Event Config.: New

LABEL
Active
Type
Community
Description
Owner
OK
Cancel

18.4 Alarm Config

Use this screen to configure alarms that occur when the sampled data exceeds the specified
threshold. To open this screen, right-click on the switch in the Device List Panel, and click
Configuration > RMON Configuration > Alarm Config. Then, select the switch that you
want to configure.
NetAtlas Workgroup User's Guide
DESCRIPTION
Select Yes to enable this event. Otherwise, select No.
Select an event type. Choices are Log and Trap.
Select Log to generate a log when an associated alarm is generated.
Select Trap to generate a trap when an associated alarm is generated.
Select both Log and Trap to generate a log entry and trap when an associated
alarm is generated.
This field displays the community (or password). You can use 1-31 printable ASCII
characters. Spaces are allowed.
Enter a description of the event. You can use 1-127 printable ASCII characters.
Spaces are allowed. You can also leave this field blank.
Enter a descriptive name of the application that creates this entry. You can use 1-31
printable ASCII characters. Spaces are allowed.
Click this to save the settings and close this screen.
Click this to discard all changes and close the screen.
Chapter 18 Configuration
195