Figure 64 Fault: Ping And Traceroute Test: Ping; Table 45 Fault: Ping And Traceroute Test: Ping - ZyXEL Communications Version 1.03 User Manual

Chapter 9 Fault

Figure 64 Fault: Ping and TraceRoute Test: Ping

The following table describes the labels in this screen.

Table 45 Fault: Ping and TraceRoute Test: Ping

LABEL
Device Name
Device IP
Target IP Address Enter the IP address of the device to which you want to test the connection from
Count
Delay
Continue
Size
Timeout
Start
Stop
Clear
No.
IP Address
bytes
ms
Status
Approximate
round trip times in
mili-seconds:
104
DESCRIPTION
This field displays the name of each switch. Select a switch to look at statistics for
one of its ports.
This field displays the corresponding IP address of the switch.
the selected switch.
Select this option and enter the number of ping test (1-15) to perform.
Enter the number of seconds (1-30) the switch is to wait between ping tests.
Select this option to perform ping tests continuously until you click Stop.
Specify the size of the ping packet (0-1472 bytes) to send.
Specify the time (1-30 seconds) the switch is to wait for a reply from the remote
device before declaring this a failed ping test.
Click Start to begin the ping connection test.
Click Stop to end the ping connection test if you select the Continue option.
Click Clear to reset the fields in this part of the screen.
This field displays the index number.
This field displays the destination IP address for this ping test.
This field displays the number of bytes sent for this ping test.
This field displays the round trip time in mili-seconds (ms).
This field indicates whether this ping test is successful or not.
NetAtlas Workgroup User's Guide