Figure 139 RMON Configuration: History Config.: New
The following table describes the labels in this screen.
Table 100 RMON Configuration: History Config.: New
LABEL
Active
Data Source
Interval
Bucket
Requested
Owner
OK
Cancel
18.3 Event Config
Use the Event Config screen to configure the actions that a switch takes when an alarm is
triggered. To open this screen, right-click on the switch in the Device List Panel, and click
Configuration > RMON Configuration > Event Config. Then, select the switch that you
want to configure.
NetAtlas Workgroup User's Guide
DESCRIPTION
Select Yes to enable this rule. Select No to disable this rule.
Select the port of the switch that the EMS polls for data. The probe sends data from
this port.
Enter the time (in seconds) between data samplings.
Specify the number of data samplings (between 1 and 100) the network manager
requests the probe to store.
Enter a descriptive name of the application that creates this entry. You can use 1-31
printable characters. Spaces are allowed.
Click this to save the settings and close this screen.
Click this to discard all changes and close the screen.
Chapter 18 Configuration
193