Table of Contents
Advertisement
2.Printer Setup
When tags whose width is less than 50.8 mm (2") are used, set the levers to the [LABEL] side.
6
Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
into place to make sure that it is closed securely.
Press the [FEED] button to confirm that the media can be fed correctly.
7
Procedure for loading media when using the external media stand
If the outer diameter of the media exceeds 127 mm (5") or the inner diameter of the core is 76.2 mm (3"), place the
media in the separately sold external media stand.
1
Load the external media stand [2] on the supports at the rear of the printer [1].
[ 1 ]
Insert the media shaft [1] into the media core for the roll media and insert the shaft into the hole
2
of the left part of the media holder [2].
[ 2 ]
Insert the right and left parts of the media holder [1] into the grooves of the external media stand
3
[2].
[ 2 ]
[ 1 ]
[ 2 ]
[ 1 ]
[ 2 ]
Loading the media 49
Advertisement
Table of Contents
