4.Troubleshooting
2
Remove the ribbon spoolers from the ribbon cores.
Cut the cut off portions neatly.
3
4
Overlay one portion on the other, aligning them horizontally, and fasten the overlay firmly with
adhesive cellophane tape.
Make two or three winds of the ribbon around the take-up (used ribbon) side roll.
5
Load the ribbon correctly.
6
P.53 "Loading the ribbon (thermal transfer method)"
If the ribbon winds become disordered
If the ribbon winds become disordered because the ribbon storage condition is poor or you dropped the ribbon when
loading it, wind the ribbon again with the procedure below. (Temporary measure)
If you have a new ribbon, replace the ribbon with that one.
P.53 "Loading the ribbon (thermal transfer method)"
Remove the ribbon spoolers from the ribbon cores.
1
78 Troubleshooting