Toshiba BV410T-GS02-QM-S Owner's Manual page 85

5.Appendix
*3 When the external media stand is used
 Near the media end, the print quality may be affected depending on the printing conditions. Confirm the end when
creating a print format. It is recommended that the print position of barcodes, etc. be apart from the media end by
at least 3 mm (0.12").
 If narrow media are used, the protective film of the print head may be scraped off at the media edge, causing the
print head to be disconnected.
 If the tail end of the media is fastened to the core with tape or glue, the load on the media could fluctuate at the
moment the tail end is peeled off. This could cause uneven transfer, having an impact on printing. Of particular
note is that in that event, the printed barcodes or 2 dimensional codes could become unreadable. Before using
such labels, be sure to confirm the codes. (For labels, the impact on printing can be avoided by attaching the media
by leaving about 200 mm (7.87") of the base from the last label. Note that in this case, after the last label is printed,
a media feed error occurs with the base, instead of a media absence error. For labels for which the media pitch is 37
mm (1.46") or less, it is possible to make a media absence error occur even without leaving the base from the last
label, as mentioned above, but for the printing of labels about 180 mm (7.09") before the end of the base, uneven
transfer may occur, having an impact on printing).
 Depending on the status of the tape at the tail end of the media, the peeled off tape may affect the sensor, causing
a media feed error to occur, not a media absence error.
 If you set [MOVE TO TEAROFF] to ON when using labels, the label gap of the media will be sent up to the end of the
peel-off table after the last label is issued, making it easy to cut the label manually. If the next one is issued with the
label left uncut manually, the label could be peeled off during back feeding, causing a paper jam.
 RFID labels should be used for continuous issuance. Depending on the pitch of the RFID label, paper jams could
occur at the time of issuance with a reversal operation, such as cut issuance, peel-off issuance and continuous
issuance with [MOVE TO TEAROFF] enabled.
 The gray portions in the figure below are outside the printing-guaranteed area. Printing in any of these portions
could affect the print quality in the printing-guaranteed area.
1.5 mm
(0.06")
[ 2 ]
1. Printing-guaranteed area
2. Area outside the printing-guaranteed area
3. Width of label upper paper/tag
4. Detector
5. Length of label upper paper/tag
A: Media feed direction
 When the peel-off module is attached, perforated media cannot be used.
 If perforated media are used, the perforations could cause transfer failures (bends and protrusions in holes) and
sensor detection failures (optical axis disturbance in holes).
 When using the cutter, cut off after the perforations to prevent transfer problems. Make adjustment with [CUT ADJ.]
until you can achieve position where the media can be cut securely while avoiding the perforations.
 If you want to use perforated label media, contact your service representative for details.
1 mm
(0.04")
[ 1 ]
1 mm
(0.04")
[ 3 ]
[ 4 ]
[ 5 ]
1.5 mm
(0.06")
[ A ]
Specifications 85