Connecting The Ac Adapter/Power Cable - Toshiba BV410T-GS02-QM-S Owner's Manual

2.Printer Setup

Connecting the AC adapter/power cable

Use the following procedure to connect the provided AC adapter and power cable to an electric outlet.
The power plug has a ground wire, so be sure to connect it to a ground terminal also.
 Use only the AC voltage specified on the rating plate.
Otherwise, it may cause fire or electric shock.
 The socket outlet shall be near the equipment and be easily accessible.
 Be sure to use the power cable* and the AC adapter supplied with this printer.
Use of a power cable or an AC adapter other than those supplied may result in fire. Moreover, do not use the power
cable or the AC adapter supplied with any device other than this printer.
* In some countries/regions, the power cable is not provided with this printer. In this case, use a power cable
approved for your country/region.
 Do not use extension cords or connect multiple wires to a single outlet.
There is a risk of fire and electric shock from exceeding the capacity of the power source.
 Do not excessively bend, damage, pull on, place heavy objects on, or heat the power cable.
There is a risk of fire and electric shock from damaging the power cable. If the power cable should ever be
damaged, ask for a replacement at your service representative.
 Be sure to connect the ground wire to the ground terminal.
There is a risk of fire and electric shock if current leaks occur. However, do not connect it to a gas pipe, water pipe,
faucet, or lightning rod, etc., which could cause an accident or malfunction.
 Do not plug or unplug the power plug with wet hands.
There is a risk of fire and electric shock from plugging or unplugging the power plug with wet hands.
 Insert the power plug fully and securely into the electric outlet.
There is a risk of fire and electric shock from not plugging the power plug in securely.
 Always hold the plug when unplugging the power plug.
There is a risk of fire and electric shock from pulling on the power cable which can break or expose the core wires.
 Unplug the power plug at least once a year and clean the blades of the plug and the area around the blades.
There is a risk of fire from the collected dust.
 Before unplugging the power cable, be sure to confirm that the printer is turned off.
There is a risk of malfunction from unplugging the power cable while the power is on.
1 Connect the DC plug [2] of the AC adapter to the power jack [1] on the back of the printer.
[ 2 ]
20 Preparing to use the printer
[ 1 ]