Precautions For The Handling Of Wireless Communication Devices - Toshiba BV410T-GS02-QM-S Owner's Manual

Precautions for the handling of Wireless Communication Devices

0.
The following precautions are specific to wireless function. See "Safety Information" for general product precautions
and regulatory information.
This product is classified as "wireless equipment for stations of low-power data transmissions systems" under the
Wireless Telegraphy Act, and does not require a radio transmission license. The law prohibits modification of the
interior of this product.
Regulatory Information
This product must be installed and used in strict accordance with the manufacturer's instructions as described in the
user documentation that comes with the product. This product complies with the following radio frequency and
safety standards.
Standards below are certified under the operation with the provided antenna. Do not use this product with other
antennas.
 Europe – EU Declaration of Conformity
Hereby, Toshiba Tec Corporation, declares that the BV410T/BV420T series are in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.
 USA – Federal Communications Commission (FCC)
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
CAUTION:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
RF EXPOSURE WARNING:
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be
provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
 Canada – Innovation, Science and Economic Development Canada (ISED)
This device complies with ISED'S licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISDE applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) cet appareil ne doit pas causer d'interférence et
(2) cet appareil doit accepter toute interférence, notamment les interférences qui peuvent affecter son
fonctionnement.
Precautions for the handling of Wireless Communication Devices 5