Toshiba BV410T-GS02-QM-S Owner's Manual page 89

5.Appendix
 For cores with an inner diameter of 25.4 mm (1.0") for overseas and domestic use
- Align the length of the core with the width of the ribbon and wind the ribbon with the ink side [A] outside.
- If the width of the ribbon is smaller than the length of the core, align the center of the ribbon with the center of
the core and wind it.
[ A ]
 If the printer is left in a hot place with the top cover closed, depending on the type of ribbon used, the ink from the
ribbon may be transferred to the paper in contact with the ribbon at the position of the print head as a black line.
 Depending on the combination of the ribbon and the media, horizontal ruled lines printed around the leading edge
of the media (within 5 mm (0.2") from the print start position) are sometimes blurry. In such cases, it is
recommended to reduce the print speed or change the type of ribbon.
 Notes on using options
Before incorporating an option, turn off the POWER button of the printer and unplug the power plug from the
electric outlet.
Incorporating an option with the power on could cause fire, electric shock, and injury. To protect the electric circuit
inside the printer, connect and disconnect cables at least 1 minute after turning off the power of the printer.
 Make sure that your fingers and hands do not get caught in covers and so on.
 Immediately after printing, do not touch the print head, stepping motor, or their surrounding areas.
This could cause burns.
 When mounting and cleaning the cutter module, do not touch the cutter blade directly.
This could cause injury.
 If you attach the cutter module and perform the cut issuance of label media, cut off the media at the gaps (base).
Avoid issuing the media by cutting off the labels. This could cause paper jams, malfunctions, and short cutter life.
 When you use the inner roll media for the cut issuance, the one with a label gap of 3 mm is recommended. A wider
gap between labels could cause paper jams.
 If the cut position is not appropriate, adjust the position with [CUT ADJ.].
For details, refer to "Key Operation Specification".
 If, during cut issuance, the media are wound onto the platen unit, change [MOVE TO TEAROFF] in the parameter
setting to [ON].
For details, refer to "Key Operation Specification".
 If, during cut issuance, the media are wound onto the platen unit, use the BCP Setting Tool to set [MOVE TO
TEAROFF] to ON.
 Using media or a ribbon that can easily generate static electricity could cause labels to stick the cutter outlet. If this
occurs, the order in which labels are ejected may be changed.
 If you attach the peel-off module and perform the peel-off issuance of label media, it may be impossible to peel off
labels correctly depending on the material of the label or the base. For details about the materials of labels and
bases, contact your service representative.
 After peel-off issuance, labels may sag down in the forward direction under their own weight, sticking to the front of
the printer or the floor. If using labels of 150 mm (5.91") or greater, make sure that they do not stick to the floor.
 In partial cut mode, a margin of 32 mm (1.26") in length is automatically added before the effective print range.
[ A ]
Specifications 89