Loading The Media; Loading The Media Roll - Toshiba BV420D-GL02-QM-S Owner's Manual

10. Loading the Media

This chapter explains how to load the media in the printer. This printer is intended for printing the media roll without
liner. Use Toshiba Tec Corporation approved media.
Do not touch the print head or around it immediately after printing.
The print head will become very hot during printing. You may get burnt if you touch it in such a condition.
 To avoid injury, be careful not to trap your fingers in the paper slot while opening or closing the top cover.
 Do not touch the print head.
Otherwise, some dots may be damaged due to static electricity or other print quality problems.
 Loading the media roll
Open the top cover.
1
For details, refer to  P.23 "9. Opening and Closing the Top Cover".
While holding the holder lock lever [1], slide the media holder [2] toward the exterior.
2
 Be sure to perform calibration of the media sensors whenever you change the media type.
For details, refer to "BV400 Series Key Operation Specification" in the CD-ROM.
 The available media size to be set in the printer is as below.
- Roll diameter: Max. 107 mm (4.2")
- Inner core diameter: 38.1 mm (1.5")
 Use the outside wound type media and load it so that the print side faces up.
Place the media roll.
3
Set the media roll [1] between the media roll holders [2] while its printing surface comes upward.
24 10. Loading the Media
[ 2 ]
[ 1 ]
[ 2 ]
[ 2 ]
[ 1 ]