Connecting To A Computer - Toshiba BV410T-GS02-QM-S Owner's Manual

2.Printer Setup

Connecting to a computer

Use the following procedure to connect to a computer.
Which communications cable to use depends on the means of communicating with the computer.
For details, consult with your service representative.
 Connecting with a LAN cable
Connect the connector of the LAN cable [2] to the LAN port [1] on the back of the printer.
1
[ 2 ]
You do not need to turn off the power to the printer or the computer.
Connect the connector on the other end of the LAN cable to the LAN port on the computer.
2
Refer to the owner's manual for the computer being used regarding how to connect to the computer.
 Use a LAN cable that is compliant with standards.
- 10BASE-T standard: Category 3 or higher
- 100BASE-TX standard: Category 5 or higher
- Cable length: Up to 100 m (328.1 ft) maximum segment length
 Communication errors may occur depending on the connected LAN environment and the noise environment.
In this case, you may need shielded cables (STP) and matching of the connected devices.
 It is recommended to change the default SNMP community name.
22 Preparing to use the printer
[ 1 ]