Table of Contents
Advertisement
2.Printer Setup
Make sure that the media guides [1] do not tighten the media too much. Tightening the media too much could
bend the media, causing paper jams and media feed failures.
Confirm that the media pass under the media guides [1].
9
[ 1 ]
In the case of an outer roll media, push the right and left edges of the media to pass it through the
10
outer roll paper hooks [1].
[ 1 ]
When passing the media through the outer roll paper hooks [1], be careful not to create wrinkles or damage it in
any way. Using a media with wrinkles or other damage could cause a print failure.
11
Set the right and left levers of the platen unit holder in accordance with the type of the media
loaded. (Label: Tilt the lever forward, Tag: Tilt the lever backward.)
TAG
LABEL
When tags whose width is less than 50.8 mm (2") are used, set the levers to the [LABEL] side.
40 Loading the media
[ 1 ]
[ 1 ]
Advertisement
Table of Contents
