Toshiba BV410T-GS02-QM-S Owner's Manual page 39

2.Printer Setup
5 Place the roll media [1] between the right and left parts of the media holder [2] so that the print
side will face upward.
[ 1 ]
[ 2 ]
[ 4 ]
 Pay attention to the rolling direction of the media when loading the media. If you load the media in the
opposite direction, printing fails.
 Cut the end of the media straight with scissors. For labels, cut the base between labels straight.
 When loading media, be careful not to damage the media damper (top) [3] and the media damper (bottom)
[4].
While holding the holder lock lever [1], slide the right and left parts of the media holder [2]
6
inward to lock the roll media firmly.
Confirm that the convex portions of the core holder fit the core.
[ 2 ]
Extend the media guides [1] to the right and left.
7
[ 1 ]
8 Pull out the media so that the end of the media will be slightly outside the media outlet and then
pass the media under the right and left media guides [1].
[ 1 ]
[ 3 ]
[ 2 ]
[ 2 ]
[ 1 ]
Loading the media 39