Loading The Media - Toshiba BV410T-GS02-QM-S Owner's Manual

Loading the media

0.
This section explains the procedure for loading media (Label/Tag) in the printer.
Use Toshiba Tec Corporation certified genuine media. For details about ordering and preparing media, contact your
service representative.
Immediately after printing, do not touch the print head or its surrounding area.
This could cause burns.
 The size of media that can be loaded in the printer is as below.
- Roll diameter: Up to 127 mm (5")
- Inner diameter of the core: 25.4 mm (1"), 38 mm (1.5"), 40 mm (1.57"), or 42 mm (1.65")
 If the outer diameter of the media exceeds 127 mm (5") or the inner diameter of the core is 76.2 mm (3"), place the
media in the separately sold external media stand.
 P.49 "Procedure for loading media when using the external media stand"
 To use media that are to be loaded in the printer for the first time, use "SENSOR" in the system mode to adjust the
sensitivity of the media detection sensors.
For details, refer to "Key Operation Specification".
 To load pre-printed media, set the threshold.
For details, refer to "Key Operation Specification".
 Before loading the media, flatten its cross-section as shown below.
 Media are available in inner roll [1] and outer roll [2], which differ as shown in the figure below. Regardless of the
rolling direction, load the media so that the print side [3] will face upward.
[ 1 ]
[ 3 ]
 Toshiba Tec Corporation shall assume no liability for any consequences of printing by loading media other than
Toshiba Tec Corporation certified ones.
[ 2 ]
[ 3 ]

Loading the media 37