Loading The Media - Toshiba BA410T Series Owner's Manual

2. PRINTER SETUP

2.3 Loading the Media

WARNING!
1. Do not touch any moving
parts. To reduce the risk of
fingers, jewellery, clothing,
etc., being drawn into the
moving parts, be sure to
load the media once the
printer has stopped moving
completely.
2. The Print Head becomes
hot immediately after
printing. Allow it to cool
before loading the media.
3. To avoid injury, be careful
not to trap your fingers
while opening or closing the
cover.
CAUTION!
1. Make sure that the Upper
Sensor Ass'y is closed
when taking out the Media
Holder Ass'y. If the Upper
Sensor Ass'y is opened, it
may be damaged.
2. Be careful not to touch the
Print Head Element when
opening the Top Cover.
Failure to do this may cause
missing dots by static
electricity or other print
quality problems.
The following procedure shows the steps to properly load the media into
the printer so that it feeds straight and true through the printer.
Use the same procedure when replacing the media, also.
The printer prints both labels and tags.
1. Press the Top Cover Release Button and gently open the Top Cover to
its fully open position supporting it with your hand.
Top Cover Release Button
2. Take out the Media Holder Ass'y from the printer.
Media Holder
Ass'y
Upper Sensor Ass'y
3. Raise the Release Lever and remove the Media Holder (Left).
Release Lever
4. Insert the Media Shaft into the core of a media roll.
3
E2-
ENGLISH VERSION
2.3 Loading the Media
Top Cover
Media Holder (Left)
Media Shaft
Spacer