Toshiba BV410T-GS02-QM-S Owner's Manual page 96

5.Appendix
 Pressing the lever in the figure below releases the ribbon spooler reverse rotation preventing lock, giving the
ribbon a slack. Be careful not to press the lever by mistake after winding the ribbon.
Close the ribbon cover until it "snaps" into place.
12
Raise the media damper (top).
13
Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
14
into place to make sure that it is closed securely.
15 Press and hold down the [FEED] button to feed the media by about 10 to 20 cm (3.94" to 7.87") to
confirm that the media can be fed correctly.
For details about loading a ribbon, be sure to carefully read the information referenced below.
 P.53 "Loading the ribbon (thermal transfer method)"
When the ribbon has run out, printing may stop halfway depending on the ribbon end detection timing. After the
ribbon is replaced with a new one and the [RESTART] key is then pressed, printing will restart from the error label.
96 Replacing the supplies