Table of Contents
Advertisement
2.Printer Setup
For φ38 mm (1.5")
From the outside of the media holder, push out both sides of the φ38 mm (1.5") core holder housed in the dent below.
Then place it on the core holder above.
For φ40 mm (1.57") and φ42 mm (1.65")
From the outside of the media holder, push out the φ40 mm (1.57") or φ42 mm (1.65") core holder until it "snaps".
To return the φ40 mm (1.57") or φ42 mm (1.65") core holder to its original position, push it while holding both sides.
42 Loading the media
Advertisement
Table of Contents
