Toshiba BV410T-GS02-QM-S Owner's Manual page 51

2.Printer Setup
Make sure that the media guides do not tighten the media too much. Tightening the media too much could bend
the media, causing paper jams and media feed failures.
Set the right and left levers of the platen unit holder in accordance with the type of the media
8
loaded. (Label: Tilt the lever forward, Tag: Tilt the lever backward.)
TAG
LABEL
When tags whose width is less than 50.8 mm (2") are used, set the levers to the [LABEL] side.
Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
9
into place to make sure that it is closed securely.
Adjust the installation position of the printer [2] toward the external media stand [1].
10
The media slot [3] of the printer is located near the right lateral [4] on its rear side.
Place the printer to the correct position as shown in the figure below.
Align the rear of the printer to the dents [5] (position [A]) of the external media stand.
Align the right lateral [4] of the printer to the position [B].
[ A ]
[ 2 ]
If the printer [2] is installed by aligning to the left and right centers of the external media stand [1], the print
quality may be affected.
Press the [FEED] button to confirm that the media can be fed correctly.
11
[ 4 ]
[ 1 ]
[ B ]
[ A ]
[ A ]
[ 4 ]
[ 3 ]
[ A ]
[ 5 ]
[ B ]
[ 1 ]
Loading the media 51