Table of Contents
Advertisement
2. PRINTER SETUP
2.7 Loading the Media
WARNING!
1. Do not touch any moving
parts. To reduce the risk
of fingers, jewellery,
clothing, etc. being drawn
into the moving parts, be
sure to load the media
once the printer has
stopped moving
completely.
2. To avoid injury, be careful
not to trap your fingers
while opening or closing
the Top Cover.
AVERTISSEMENT!
1. Ne touchez pas aux
parties mobiles. Pour
réduire le risque de
prendre vos doigts,
bijoux ou vêtements
dans les parties
mobiles, mettez
l'interrupteur en position
arrêt pour stopper le
mécanisme.
2. Pour prévenir tout
dommage, évitez
d'accrocher ou de coincer
tous objets dans le
mécanisme.
CAUTION!
Be careful not to touch the
Print Head Element when
opening the Top Cover.
Failure to do this may cause
missing dots by static
electricity or other print quality
problems.
ATTENTION!
Prenez garde à ne pas
toucher les éléments actifs de
la tête en levant le bloc de
tête. L'électricité statique peut
engendrer des problèmes de
qualité d'impression ou
endommager des points de
tête.
This section describes how to load a media in the printer. This printer
accepts Linerless label rolls. Please use TOSHIBA TEC approved media.
NOTES:
1. Please perform a media sensor calibration when you use a label
which has gaps.
2. The size of the media which can be loaded inside the printer is as
follows:
Outer roll diameter: Max. 127mm (5")
Inner core diameter: 25.4 (1") mm or 38.1 mm (1.5")
* 1.5" is recommended.
3. Some media rolls are wound inside and the others are wound outside.
(See the diagram below.) Outside wound type of media roll should
be loaded so that the print side faces up.
Outside wound
1. Press down the Top Cover Release Button to unlock the Top Cover,
and then fully open the Top Cover.
Top Cover
E2- 7
ENGLISH VERSION EO1-33095
2.7 Loading the Media
Inside wound
Top Cover Release
Button
Advertisement
Table of Contents
