Ribbon - Toshiba BV410T-GS02-QM-S Owner's Manual

5.Appendix
9 Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
into place to make sure that it is closed securely.
Press and hold down the [FEED] button to feed the media by about 10 to 20 cm (3.94" to 7.87") to
10
confirm that the media can be fed correctly.
For details about loading media, be sure to carefully read the information referenced below.
 P.37 "Loading the media"

Ribbon

This section explains the procedure for replacing the ribbon with a new one of the same type and the same width.
Use a Toshiba Tec Corporation certified genuine ribbon.
Open the top cover.
1
 Immediately after printing, do not touch the print head or its surrounding area.
This could cause burns.
Push down the media damper (top).
2
Push down the media damper (top) gently. Holding or pulling the media damper (top) strongly could cause
malfunctions.
Open the ribbon cover.
3
92 Replacing the supplies