Toshiba BV410T-GS02-QM-S Owner's Manual page 41

2.Printer Setup
12 Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
into place to make sure that it is closed securely.
Press and hold down the [FEED] button to feed the media by about 10 to 20 cm (3.94" to 7.87") to
13
confirm that the media can be fed correctly.
When you load media that use the reflective sensor, adjust the position of the reflective sensor.
 P.59 "Adjusting the position of the reflective sensor (movable)"
 Moving the core holder
Move the core holder to one of the positions shown in the figure below to match the inner diameter of the media core
for the roll media being used.
[ A ]
[A] φ25.4 mm (1")
[B] φ38 mm (1.5")
[C] φ40 mm (1.57"), φ42 mm (1.65")
For φ25.4 mm (1")
Hold both sides of the φ38 mm (1.5") core holder and pull it towards you to house it in the dent below.
[ B ] [ C ]
Loading the media 41