Table of Contents
Advertisement
2.Printer Setup
6
In the case of an outer roll media, push the right and left edges of the media to pass it through the
outer roll paper hooks [1].
[ 1 ]
When passing the media through the outer roll paper hooks [1], be careful not to create wrinkles or damage it in
any way. Using a media with wrinkles or other damage could cause a print failure.
Set the right and left levers of the platen unit holder in accordance with the type of the media
7
loaded. (Label: Tilt the lever forward, Tag: Tilt the lever backward.)
TAG
LABEL
When tags whose width is less than 50.8 mm (2") are used, set the levers to the [LABEL] side.
Pass the base [1] between the peel-off feed roller [2] and the peel-off plate.
8
[ 1 ]
[ A ]
[ 2 ]
If the base is loose, the peel-off module may be opened during operation. Confirm that there is no
9
slack in portion A in the figure above. While pulling the base [1] slightly as in the figure below,
close the peel-off module [2].
[ 2 ]
[ 1 ]
46 Loading the media
[ 1 ]
Advertisement
Table of Contents
