Table of Contents
Advertisement
Figure 79. Installing drive backplane carrier assembly
a.
Align the bottom of the carrier to the slots in the server.
b.
Pivot the top of the carrier until it clicks into place.
After you finish
1. Connect the power and signal cables to all the backplanes. See
on page 292
for more information on the internal cable routing.
2. Reinstall all the 2.5-inch hot-swap drive and drive fillers. See
116.
3. Reinstall the fan cage. See
4. Reinstall all fan modules. See
5. Reinstall the front air baffle. See
6. Reinstall the front top cover. See
7. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
Fan and fan cage replacement
Follow instructions in this section to remove or install the fans and the fan cage assembly.
Remove a fan module
Follow the instructions in this section to remove a fan module.
About this task
S014
"Install the fan cage" on page
"Install a fan module" on page
"Install the front air baffle" on page
"Install the front top cover" on page
"Complete the parts replacement" on page
"2.5-inch drive backplane cable routing"
"Install a 2.5-inch hot-swap drive" on page
129.
131.
90.
278.
.
Chapter 5
Hardware replacement procedures
281.
125
Advertisement
Chapters
Table of Contents
