Lenovo ThinkSystem SR860 V3 User Manual page 183

About this task
Attention:
• Read "Installation Guidelines" on page 43
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr860v3/7d93/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 435
Procedure
Step 1. If a filler is installed, remove it.
Step 2. Install the OCP module.
Figure 121. Installing OCP module
a. Slide the OCP module into the slot until it is fully seated.
b. Tighten the thumbscrew to secure the OCP module.
After you finish
Complete the parts replacement. See
Demo video
and "Safety inspection checklist" on page 44
58.
for more information on firmware updating tools.
"Complete the parts replacement" on page 281.
.
Chapter 5 Hardware replacement procedures
to ensure that you
173