Figure 214. System board assembly installation
a.
Grasp the plunger and blue handle; then, insert the shorter side of the system board
assembly into the chassis.
b.
Lower the longer side of the system board assembly down into the chassis.
c.
Slide the system board assembly towards the rear of the chassis until the plunger clicks into
place. Ensure that rear connectors on the system I/O board are inserted into the corresponding
holes in the rear panel.
After you finish
1. Reconnect all the cables to the system board assembly. See
283.
2. Reinstall the serial port module. See
3. Reinstall the memory modules. See
4. Reinstall the PHMs. See
5. Reinstall the power backplane. See
6. Reinstall the rear air baffle. See
7. Reinstall all the PCIe risers. See
8. Reinstall the crossbar. See
9. Reinstall the front air baffle. See
10. Reinstall the fan cage. See
11. Reinstall all fan modules. See
12. Reinstall the rear top cover. See
13. Reinstall the front top cover. See
"Install the serial port module" on page
"Install a memory module" on page
"Install a processor and heat sink" on page
"Install the power backplane" on page
"Install the rear air baffle" on page
"Install the PCIe riser" on page
"Install the crossbar" on page
"Install the front air baffle" on page
"Install the fan cage" on page
"Install a fan module" on page
"Install the rear top cover" on page
"Install the front top cover" on page
Chapter 6 "Internal cable routing" on page
253.
166.
243.
222.
98.
187.
112.
90.
129.
131.
276.
278.
.
Chapter 5
Hardware replacement procedures
267