Figure 191. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Procedure
Step 1.
Make preparation for the task.
a.
To replace a front PHM (processor 3 or 4), remove the following:
1. Remove the front top cover. See
2. Remove the front air baffle. See
b.
To replace a rear PHM (processor 1 or 2), remove the following:
1. Remove the front top cover. See
2. Remove the rear top cover. See
Clips to secure processor in carrier
9
Processor ejector handle
10
Carrier triangular mark
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
"Remove the front top cover" on page
"Remove the front air baffle" on page
"Remove the front top cover" on page
"Remove the rear top cover" on page
.
Chapter 5
272.
87.
272.
274.
Hardware replacement procedures
239