Table of Contents
Advertisement
Figure 22. Disassembling 7mm drive cage
a.
Unfasten the two screws from the upper backplane; then, remove the upper backplane from
the lower backplane.
b.
Unfasten the screw from the lower backplane; then, remove the lower backplane from the
drive cage.
Step 6.
If necessary, install the 7mm drive cage bracket to the filler.
Figure 23. Installing 7mm drive cage bracket
a.
Align the 7mm drive cage bracket with the filler and slide it towards the rear of the filler.
b.
Secure the 7mm drive cage bracket with a screw.
Step 7.
If necessary, install the 7mm drive cage filler.
.
Chapter 5
Hardware replacement procedures
77
Advertisement
Chapters
Table of Contents
