Table of Contents
Advertisement
Note: To prevent the contacts of the system I/O board from damage, ensure that the system I/
O board is aligned correctly with the connector on the processor board, and remains as
horizontal as possible during the insertion.
b.
Lower the system I/O board onto the supporting sheet metal. Make sure the plunger
engages with the supporting sheet metal.
c.
Install the screws to fix the system I/O board into place.
Step 3.
If you installed a new system I/O board onto the processor board, install the firmware and RoT
security module and MicroSD card that was removed from the old system I/O board onto the new
system I/O board. See
MicroSD card" on page
Step 4.
Place the system board assembly in the chassis.
ThinkSystem SR860 V3 User Guide
266
"Install the firmware and RoT security module" on page 259
170.
and
"Install the
Advertisement
Chapters
Table of Contents
