Lenovo ThinkSystem SR860 V3 User Manual page 213

Figure 152. Installing PCIe riser card to riser
Install a PCIe riser card and cage to six slot FH riser
Note: A Gen 4 riser is used as an example for illustration. The replacement procedure for a Gen 5 riser is
similar.
Procedure
Step 1. If necessary, attach the labels onto the straight-end of the PCIe riser cables.
Note: See "PCIe riser 1 cable routing" on page 424
identify the corresponding labels for the cables.
Figure 153. PCIe riser cable
Straight-end of cable (connects to system board
1
assembly)
Label (located near straight-end of cable)
2
or "PCIe riser 3 cable routing" on page 428
Right-angle end of cable (connects to riser card)
3
Label sheet for PCIe riser cable (from labels kit)
4
.
Chapter 5 Hardware replacement procedures
to
203