Lenovo ThinkSystem SR860 V3 User Manual page 255

Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr860v3/7d93/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 435
Procedure
Step 1. Record the processor identification label.
• If you are replacing a processor and reusing the heat sink, remove the processor identification
label from the heat sink and replace it with the new label that comes with the replacement
processor.
• If you are replacing a heat sink and reusing the processor, remove the processor identification
label from the old heat sink and place it on the new heat sink in the same location.
Note: If you are unable to remove the label and place it on the new heat sink, or if the label is
damaged during transfer, write the processor serial number from the processor identification
label on the new heat sink in the same location as the label would be placed using a permanent
marker.
Step 2. Install the processor in the new carrier.
Notes:
• If you are replacing the processor and reusing the heat sink, use the new carrier that comes with
the new processor.
• If you are replacing the heat sink and reusing the processor, and if the new heat sink comes with
two processor carriers, make sure to use the same type of carrier as the one you discarded.
Clips to secure processor in carrier
9
Processor ejector handle
10
Carrier triangular mark
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
for more information on firmware updating tools.
Chapter 5
.
Hardware replacement procedures
245