Table of Contents
Advertisement
2. Reinstall all the hot-swap drives and drive bay fillers (if any) into the drive bays. See "Install a hot-swap
drive" on page 84.
3. Reinstall the front bezel. See "Install the front bezel" on page 106.
4. Reinstall the front door. See "Install the front door" on page 109.
5. Reinstall the server cover. See "Install the server cover" on page 190.
6. Complete the parts replacement. See "Complete the parts replacement" on page 206.
Fan and fan cage replacement
Use this procedure to remove or install fan and fan cage assembly.
Remove a hot-swap fan
Use this procedure to remove a hot-swap fan.
About this task
S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read "Installation guidelines" on page 57 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• If the server is in a rack, remove it from the rack.
• If foot stands are installed on the server, rotate them inwards and lay the server on its side for easier
operation.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
.
Chapter 4
Hardware replacement procedures
93
Advertisement
Table of Contents
