Table of Contents
Advertisement
Install PCIe riser 1
Procedure
Step 1.
If necessary, install the PCIe adapters. See
Step 2.
If a PCIe riser filler has been installed, remove it.
Step 3.
Install PCIe riser 1.
Figure 137. Installing PCIe riser 1
a.
Connect all internal cables to the PCIe adapters.
b.
For six slot FH risers, route all internal cables through the cable retainer as shown below.
RAID/HBA to backplane 1, 3, 4, or 6
c.
Connect the power cable to the PCIe riser; then, align and install the PCIe riser until it rests
firmly on top of the kickstands.
d.
Connect the PCIe riser 1 cables to the system board assembly. See
routing" on page 424
"Install a PCIe adapter" on page
for more information on the internal cable routing.
183.
RAID/HBA to flash power module, backplane 2
or 5
"PCIe riser 1 cable
.
Chapter 5
Hardware replacement procedures
191
Advertisement
Chapters
Table of Contents
