Lenovo ThinkSystem SR860 V3 User Manual page 147

Procedure
Step 1. Make preparation for the task.
a. Remove the front top cover. See
b. Remove the rear top cover. See
c. Remove the crossbar. See
d. Remove the PCIe riser where the GPU is installed. See
Step 2. Remove the GPU adapter link bridge from the GPUs with a suction cup.
Figure 88. Removing the GPU adapter link bridge
a. Press the suction cup against the GPU adapter link bridge until it adheres to the GPU
adapter link bridge.
b. Pull up the suction cup and remove the GPU adapter link bridge together with the suction
cup from the GPUs.
Step 3. Repeat Step 2 on page 137
Note: Remove all GPU adapter link bridges from the GPUs.
After you finish
1. If you are not installing a replacement unit, install a link connector cover onto the GPUs.
"Remove the front top cover" on page
"Remove the rear top cover" on page
"Remove the crossbar" on page
to remove the other GPU adapter link bridges.
272.
274.
109.
"Remove the PCIe riser" on page
.
Chapter 5 Hardware replacement procedures
174.
137