Figure 24. Installing 7mm drive cage filler
a.
Install the filler into the PCIe riser cage.
b.
Secure the filler with two screws.
Remove 7mm drive cage from six slot FH riser
Note: A Gen 4 riser is used as an example for illustration. The replacement procedure for a Gen 5 riser is
similar.
Procedure
Step 1.
Make preparation for the task.
a.
If 7mm drives or fillers have been installed, remove them. See
73.
b.
Remove the front top cover. See
c.
Remove the rear top cover. See
d.
Remove the crossbar. See
e.
Remove the PCIe riser where the 7mm drive cage is installed. See
page
174.
Step 2.
Disconnect the cables from the 7mm drive cage.
Step 3.
Remove the 7mm drive cage.
ThinkSystem SR860 V3 User Guide
78
"Remove the front top cover" on page
"Remove the rear top cover" on page
"Remove the crossbar" on page
"Remove a 7mm drive" on page
272.
274.
109.
"Remove the PCIe riser" on