Lenovo ThinkSystem SR860 V3 User Manual page 127

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Note: For a complete list of supported optional device for this server, see
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to https://datacentersupport.lenovo.com/products/servers/thinksystem/sr860v3/7d93/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 435
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server; then, take the new part out of the package and place it on a static-protective
surface.
Step 2. If a drive filler has been installed in the drive bay, remove it.
Step 3. Install the 2.5-inch drive.
Figure 72. Installing a 2.5-inch drive
a. Ensure that the tray handle is in the open position. Slide the drive into the drive bay, and
push it until it stops.
b. Rotate the handle back to the locked position.
After you finish
1. Check the drive status LED to verify if the drive is operating correctly.
• If the yellow LED is lit continuously, it is malfunctioning and must be replaced.
• If the green LED is flashing, the drive is functioning.
Note: If the server is configured for RAID operation through a ThinkSystem RAID adapter, you might
have to reconfigure your disk arrays after you install drives. See the ThinkSystem RAID adapter
documentation for additional information about RAID operation and complete instructions for using
ThinkSystem RAID adapter.
for more information on firmware updating tools.
Chapter 5
https://serverproven.lenovo.com
.
Hardware replacement procedures
.
117