Lenovo ThinkSystem SR860 V3 User Manual page 244

S035
CAUTION:
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage,
current, and energy levels are present inside any component that has this label attached. There are no
serviceable parts inside these components. If you suspect a problem with one of these parts, contact
a service technician.
Attention: Read "Installation Guidelines" on page 43
that you work safely.
Procedure
Step 1. Disconnect both ends of the power cord and keep it in an ESD-safe place.
Step 2. Remove the power supply.
Notes:
• A CFFv4 power supply is used as an example for illustration. The replacement procedure for
CRPS power supply is similar.
• The color of the CRPS handle might be different from the image.
Figure 189. Removing the power supply
a. Press and hold on the orange release tab.
b. Grasp the handle and slide the power supply unit out from the server.
After you finish
1. Install a replacement unit or filler. See
ThinkSystem SR860 V3 User Guide
234
and "Safety inspection checklist" on page 44
"Install a hot-swap power supply unit" on page
to ensure
235.