Lenovo Converged HX Series Installation And Service Manual page 205

2. Remove and install the power supply unit, and make sure it is properly connected to the power.
3. If the error recurs, replace the power supply units.
4. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
0B0109A3
0B0109A4
Full Sensor Name (Sensor Name In SDR):
PSU%_POUT (% = PSU number)
Sensor Type:
Other Units-based sensor
Event Severity:
Critical
Description:
Upper Critical - Going High - Asserted
Message:
PSU output power is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Remove and install the power supply unit, and make sure it is properly connected to the power.
3. If the error recurs, replace the power supply units.
4. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
01010BA5
01010BA6
Full Sensor Name (Sensor Name In SDR):
PSU%_Temp (% = PSU number)
Sensor Type:
Temperature
Event Severity:
Critical
Description:
Upper Non-Recoverable - Going High - Asserted
Message:
PSU ambient temperature is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Remove and install the power supply unit, and make sure it is properly connected to the power.
3. If the error recurs, replace the power supply units.
4. If the error recurs, contact Lenovo service representative for technical support.
Appendix A. TMM error messages
191