Lenovo Converged HX Series Installation And Service Manual page 216

Event Severity:
Info
Description:
Initiated by warm reset - Asserted
Message:
BIOS boot up and it's initiated by warm reset.
Actions:
Information only. There is no need to do anything for this message.
• Diagnostic Code:
0C6F00E2
Full Sensor Name (Sensor Name In SDR):
Memory_Status
Sensor Type:
Memory
Event Severity:
Critical
Description:
Correctable ECC or other correctable memory error - Asserted
Message:
A single bit error is occurred In memory. This error will be repaired automatically.
Actions:
1. 1. If the node has recently been installed, moved, serviced, or upgraded, verify that the DIMM is
properly seated and visually verify that there is no foreign material in any DIMM connector on that
memory channel. If either of these conditions is found, eliminate the situation and try again with the
same DIMMs.
2. If the error recurs on the same DIMM connector, swap the other DIMMs on the same memory channel
across channels one at a time to a different memory channel or processor. (check service information
for this Product Install Guide for population requirements for sparing modes). If the error follows a
moved DIMM to a different memory channel, replace that DIMM.
• Diagnostic Code:
0C6F01E2
Full Sensor Name (Sensor Name In SDR):
Memory_Status
Sensor Type:
Memory
Event Severity:
Critical
Description:
Uncorrectable ECC or other uncorrectable memory error - Asserted
Message:
A multiple bits error is occurred in memory. This error will cause system to be hang up.
Actions:
202
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide