Lenovo Converged HX Series Installation And Service Manual page 196

Upper Critical - Going High - Asserted
Message:
Node intput voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010793
Full Sensor Name (Sensor Name In SDR):
Node_VIN
Sensor Type:
Other Units-based sensor
Event Severity:
Warning
Description:
Upper Non-Critical - Going High - Asserted
Message:
Node intput voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010094
Full Sensor Name (Sensor Name In SDR):
Node_VOUT
Sensor Type:
Other Units-based sensor
Event Severity:
Warning
Description:
Lower Non-Critical - Going Low - Asserted
Message:
Node output voltage is too low
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
182
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide