Lenovo Converged HX Series Installation And Service Manual page 208

Upper Non-Recoverable - Going High - Asserted
Message:
HDD backplane power consumption is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. reseat the hard disk drive backplane, and make sure it is properly installed.
3. Power cycles the chassis.
4. If the error recurs, replace the hard disk drive backplane.
5. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
0B0109AB
Full Sensor Name (Sensor Name In SDR):
HDD_BP_Power
Sensor Type:
Other Units-based sensor
Event Severity:
Critical
Description:
Upper Critical - Going High - Asserted
Message:
HDD backplane power consumption is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. reseat the hard disk drive backplane, and make sure it is properly installed.
3. Power cycles the chassis.
4. If the error recurs, replace the hard disk drive backplane.
5. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
160901C0
Full Sensor Name (Sensor Name In SDR):
BMC_Boot_Up
Sensor Type:
Microcontroller / Coprocessor
Event Severity:
Info
Description:
Device Enabled - Asserted
Message:
BMC boot up successfully.
194
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide