Lenovo Converged HX Series Installation And Service Manual page 110

Hard disk drive (HDD) location vs. hard disk drive signal mapping table
HDD (Front
location HDD)
HDD0
PCH SATA port
SATA 3
mode
ID 2
PCH SW
RAID
mode
(RSTe)
HBA
Slot 0
adapter
installed
(RAID
mode)
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
To install a hot-swap SAS or SATA hard disk drive, complete the following steps:
Note: If you have only one hard disk drive, you must install it in the left drive bay.
Attention: To avoid damage to the hard disk drive connectors, make sure that the server cover is in place
and fully closed whenever you install or remove a hard disk drive.
Step 1. Remove the filler panel from the empty drive bay. Keep the filler panel in a safe place.
Step 2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 3. Install the hard disk drive in the drive bay:
a. Make sure that the tray handle is in the open (unlocked) position.
b. Align the drive with the guide rails in the bay.
Handle
Figure 31. Hot-swap hard disk drive installation
96
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
(Front (Front
HDD) HDD)
HDD1 HDD2
SATA port SATA port
4 5
ID 3 ID 4
Slot 1 Slot 2
2.5-inch hot-swap
hard disk drive
Filler panel handle
(Front (Front
HDD) HDD)
HDD3 HDD4
SATA port sSATA
6 port 1
ID 5 ID 0
Slot 3 Slot 4
(Front (internal
HDD) connec-
HDD5 tor)
SATA1 /
SATA-
DOM
sSATA SATA port
port 2 1
ID 1
SATA port
1
Slot 5 SATA port
1
(internal
connec-
tor)
SATA2/
Not use
SATA port
2 (Not use)
SATA port
2 (Not use)
SATA port
2 (Not use)