Lenovo Converged HX Series Installation And Service Manual page 176

Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010011
Full Sensor Name (Sensor Name In SDR):
SYS_5V
Sensor Type:
Voltage
Event Severity:
Warning
Description:
Lower Non-Critical - Going Low - Asserted
Message:
5V voltage is too low
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010B11
Full Sensor Name (Sensor Name In SDR):
SYS_5V
Sensor Type:
Voltage
Event Severity:
Critical
Description:
Upper Non-Recoverable - Going High - Asserted
Message:
5V voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010911
Full Sensor Name (Sensor Name In SDR):
SYS_5V
Sensor Type:
162
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide