Lenovo Converged HX Series Installation And Service Manual page 198

Node_VOUT
Sensor Type:
Other Units-based sensor
Event Severity:
Warning
Description:
Upper Non-Critical - Going High - Asserted
Message:
Node output voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010B95
Full Sensor Name (Sensor Name In SDR):
Node_PIN
Sensor Type:
Other Units-based sensor
Event Severity:
Critical
Description:
Upper Non-Recoverable - Going High - Asserted
Message:
Node input power is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010995
Full Sensor Name (Sensor Name In SDR):
Node_PIN
Sensor Type:
Other Units-based sensor
Event Severity:
Critical
Description:
184
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide