Lenovo Converged HX Series Installation And Service Manual page 193

Upper Critical - Going High - Asserted
Message:
Node input current is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010791
Full Sensor Name (Sensor Name In SDR):
Node_IIN
Sensor Type:
Other Units-based sensor
Event Severity:
Warning
Description:
Upper Non-Critical - Going High - Asserted
Message:
Node input current is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
3. If the error recurs, contact Lenovo service representative for execution of power interface board
replacement.
• Diagnostic Code:
0B010B92
Full Sensor Name (Sensor Name In SDR):
Node_IOUT
Sensor Type:
Other Units-based sensor
Event Severity:
Critical
Description:
Upper Non-Recoverable - Going High - Asserted
Message:
Node output current is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
Appendix A. TMM error messages
179